Irrpod_Catalogue - page 48

18 Page
|
Section Two - Irripod
Effluent
- Technical Information
|
September 2011
Step 1
A.
Turn the Isolating Valve off, this is
located on the 90mm Adaptor Set
(Part A).
B.
Turn all the Pod Sprinkler Valves off
at the Pod Hydrants (Part B).
Step 2
Remove the Hansen™ Tow System from
the Male Camlock at the opposite end of
the Pod Sprinkler Line (Part D).
Movement
Line 1
Part B -
Sub Main Set
Part D - Pod Sprinkler Lines
Part A -
90mm Adaptor Set
(In middle of paddock)
Hansen Tow System
63mm Drag Hose
(Not Included)
Part C - Pod Hydrants
Mainline pipe from
Effluent Pump
Movement One
Movement Two
Movement Three
Livestock Movement Lane
Step 3
A.
Disconnect the Male Camlock at
the Pod Hydrant end (Part C).
B.
Connect the Hansen™ Tow
System to the Male Camlock.
Step 5
Connect the Pod Sprinkler Line to the
Pod Hydrant and turn the Pod Sprinkler
Line to the on position.
Repeat steps 2 to 5 until all the Pod
Sprinkler Lines have been relocated.
Turn the Isolating Valve on and begin
irrigating.
When the desired level of effluent has
been applied to the paddock turn the
Isolating Valve off; this is located on the
90mm Adaptor Set (Part A).
Step 4
Attach the Pod Sprinkler line to an ATV and Proceed to drag the
line across the sub main pipe in the opposite direction of the
previous location of the line.
NOTE:
Your Irripod Effluent system has been designed to be turned off when
moving the Pod Sprinkler Lines.
Moving Effluent Pod Sprinkler Lines
Turn
Off
A
B
Turn
Off
Turn
On
B
A
Email:
info@hansenproducts.com
Website:
www.hansenproducts.com
1...,38,39,40,41,42,43,44,45,46,47 49,50,51,52,53,54,55,56,57,58,...64
Powered by FlippingBook